LED Tube lights are very popular these days and its installation is not that hard. You can do it at home yourself as well but only if you are confident and careful and follow all the instructions in the manual properly. Even then it is best advised to hire a electrician because they take very less money for fixing it. The parts of the tubelights are pretty small and delicate and may break if more pressure is applied and above that there are chances of you getting a shock. So do not hesistate to hire an electrician if you are not sure about your knowledge. And for that you can call Patna Repair to have expert electricians at your home within 24 hours.

 How are LED tube lights installed?

LED tubes are installed in the following ways but be careful which brand you are buying there may be minor but important changes in the steps:

1.  Distinction of the lighting installation you are supplanting from the force supply. Endeavoring to supplant a live cylinder is probably going to bring about an electric stun. When the force is disengaged, eliminate the old cylinder from the fitting. Make certain to deal with fluorescent cylinders with care. They contain limited quantities of mercury, which, while not unsafe during typical use, may adversely affect your wellbeing whenever ingested. Spot the old cylinder on a level surface far removed. 
2. Fluorescent installations all contain stabilizer, which will be one of two kinds: electronic or attractive. In case you don't know which sort of counterweight is fused in a light fitting, tune in for a weak humming, or search for a flashing in the light. In the event that you can see or hear this, it is probably going to be an attractive weight. Then again, snap a photo of the light (while it is on) with your cell phone. In the event that the subsequent picture has dark bars or stripes across it, the light contains an attractive counterbalance. Assuming the picture is clear, it is an electronic counterbalance. 
3. In the event that the fitting contains an electronic stabilizer, you should eliminate it to forestall harm to the LED tube. Detach the wires from the balance unit. Eliminate the unit and associate the free wires to shape a circuit. Guarantee the associations are secure and protected 
4. Contingent upon the installation and the cylinder, you will either have to eliminate or sidestep an attractive counterbalance, or simply eliminate the starter (a little unit inside the fitting that looks similar to a round and hollow 9-volt battery). Many LED tubes are bundled with a LED starter to make establishment simpler. Be that as it may, in the event that you need or wish to sidestep the weight, we'd encourage you to counsel an expert circuit repairman. 
5. Cautiously associate your new LED cylinder to the installation. The cylinder will have a live association toward one side and an unbiased association at the other. Guarantee the wires in the fitment match this. In the event that you interface both live and impartial to one finish of the LED tube, you'll cause a short out. Prior to actuating the light, guarantee that all means have been checked completely, and there are no wires left free. Switch the light on and watch that it is working effectively. Driven cylinders ought not glint or buzz.

If you still are not very sure if you understood it properly and will be able to perform it, do not try to be a hero, simply pick up your phone and call Patna Repair!

Still have questions? Before contacting us you might want to look through the questions and answers in this section.

Please click on the questions in order to read the answers.